I don't have any photographs of what happened to the miniature because I immediately grabbed a big brush of water and cleaned the stuff off the miniature as best as I could. So, what happened with the ink wash was that it beaded up rather than flowing into recesses. I asked Ghool about this online, and he confirmed that this is how it goes with brush-on, although the same product behaves differently when airbrushed on. It's a bit like painting Bones plastic, if you've ever had that experience: the paint pulls into pools on the base coat, requiring multiple layers just to achieve coverage. The Vallejo Surface Primer, when brushed on, has strange hyrdophobic properties. The result was immediately recognizable as a failure. I tried this, using my homemade ink wash based on Lester Bursley's recipe, starting with Avric Albright. The result is similar in spirit to zenithal priming: it pre-shades the recesses. Before he got into zenithal priming, however, Sorastro mentioned a technique in his Jain Fairwood video where he primes in white and then applies a thin wash over the model. One of the main reasons I have avoided thinking about this is that it would require me to clean the garage workbench to make room for a spray station. This looks like a nice way to start a model, but from what I understand, it requires an airbrush, and that's an investment I have not been willing to make. This involves priming the figure black, then laying down a layer of grey primer from about 45 degrees, and then a layer of white primer from above. In Sorastro's newer videos, he has been using zenithal priming, which is a form of pre-shading. That is, looking at it as a design problem, my fitness function was essentially "Is this model painted well enough that I can be proud of it when it hits the table, without spending inordinate effort?" He pays great attention to detail to get a very high tabletop quality I was more interested in getting decent results to the table quickly. For my overall approach, I was inspired by Sorastro's painting techniques, where he generally uses a base coat, wash, and highlight. I used two coats to get a good, clean layer of primer over the plastic. As per FFG/Runebound tradition, none of the pictured characters are in the box.Īfter trimming off mold lines, I decided to prime all the heroes using Vallejo Grey Surface Primer, applying by brush as per Ghool's video tutorial. For the heroes, I prioritized the painting of the three that we wanted to use as heroes first the low priority of the rest is the main reason it took so long to finish the set. I am happy to report on the completion of my Descent: Journeys in the Dark, 2nd Edition miniature painting project-a project that spanned a few other painting projects in between! In this part, I report on the heroes, following up on my completion of the monsters back in March.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |